Drain hook up kitchen sink
A double-bowl drain kit will have everything the single-bowl kit has along with a waste-Tee connection and additional length of drain line to connect both bowls to a single P-trap. After growing up in construction and with more than 30 years in the field, she believes a girl can swing a hammer with the best of them.
Two adjustable wrenches
The drain trap consists of a U-shaped piece and a J-shaped arm piece. If you have installed a new drain tee in the wall, now is the time to make sure all those joints are secure and permanent. Disassemble any existing drain-pipe assembly. Cut drain hook up kitchen sink a hacksaw and reattach.
Adjust as needed to create the most direct path from sink to wall tee. What may be referred to as the "drain pipes" is actually three key pieces, coupled together -- the sink drain tailpiece, which runs from the sink down to the curving pipes; the curving portion of the drain pipes, called a trap due to the fact that it captures or rather contains sewer gasses; and the actual drain pipe itself, hidden inside the walls. Lay some rags directly below each connection so that, if there is a leak, the towels will immediately soak up the water. The only thing that matters is that they all eventually get connected together.
Tools List for Installing the Plumbing for a Kitchen Sink
Connect the straight piece running from the drain similarly. If you have a multiple bowl sink, all of the drain tailpieces should be the same length for an easier installation. Tighten the slip nuts with channel-type pliers.
Be sure to include a P-trap located as close to the drainage pipe that is coming out of the wall or floor as possible. Apply a thin beading of plumbers putty around the circumference of the drain hook up kitchen sink in the sink bowl.
Remove the trap and cut the horizontal section to fit. You have a couple of choices for drain kits: Twist open the shut-off valves and check for leaks. Karie Fay earned a Bachelor of Science in psychology with a minor in law from the University of Arkansas at Monticello. Secure it with a slip nut slipped over the tailpiece and threaded onto the bottom of the sink strainer Slide the end of the continuous waste pipe into the side outlet on the drain tee fitting, then slide the assembly onto the sink tailpiece and garbage disposal drain pipe.
If you have a garbage disposal, this measurement will between the sink strainer and the drain outlet on the disposal; if you have no disposal, just measure between the centers of the two drain openings. Install the garbage disposal onto the desired side of the sink first, since this takes up the most space. That's the only difference -- doing it twice.
Basic plumbing skills required. Kitchen drain pipes may look complicated to install and tempt you to call a plumber. Take care to face the trap the correct way. Continue to 4 of 6 below.
Attach a shut-off valve to a length of copper tubing. Difficulty Level Easy-to-Moderate Tools