Ice maker hookup instructions, required tools for this project
Insert the extension tube into the smaller hole on the back of the freezer wall Image 1.
Tighten all three nuts on the quick-tee adapter with pliers or an adjustable wrench. Run the new supply tube to the back of the refrigerator. Attach the fill tube to the freezer by sliding the angled part of the tube into the inlet hole in the back of the freezer and screw it into place.
Now that the water line has been run to the refrigerator, it's time to do what's called the "tap-in" to the cold water line underneath the sink. Disconnect the Existing Water Line. Cecilia Harsch has been writing professionally since First, locate the shutoff ice maker hookup instructions under the kitchen sink where you want to connect the new water line.
How to Install a Dishwasher 7 Steps. If tightening the connection does not stop the leak, turn off the water, remove the connector and add additional thread-seal tape before reconnecting the water line. Connect the Tee Adapter.
Tapping the Cold Water Line
Once the assembly has cooled, close the new valve and open the water main to check the fittings for leaks. Coil the excess water line behind the refrigerator. To tap into the line, shut off the water to the house at the main. About the Author Thomas Ferraioli began writing in Be sure to keep the spacing equal to prevent leaking.
Turn the cold water supply valve on beneath the sink. Avoid last-minute shopping trips by having all your materials ready ahead of time. Consult local plumbing codes to be sure what you do is permitted; for instance, saddle valves are not allowed by Massachusetts building codes. Finally, drain the lines by opening a faucet.
She attended Tarrant County College and studied English composition. Figure 6 to 8 ft. It's a good idea to have a pair of needle nose pliers handy to grab the wiring ice maker hookup instructions behind the large hole in the back of the freezer.
If there is no water dispenser, throw away the first full batch or two of ice to make sure it is all clean and ready to use. Take caution to not allow water to seep into your drill and make sure to only pierce one side of the pipe.
Find your water supply lines beneath your sink. Turn the cold water on the supply line clockwise to close it. Connect a Refrigerator to an Icemaker HammerZone. Adapt-a-Tees can be used in many situations where you need an extra line. It has a tiny shutoff valve that uses a sharp pointed metal rod to pierce the outer wall of the pipe when screwed inward. Then attach the tubing to the back of the cabinets every 2 to 4 ft.
Drain the Water Line Now that the water line has been run to the refrigerator, it's time to do what's called the "tap-in" to the cold water line underneath the sink.
- Free social dating site in india
- Swiss christian dating site
- Speed dating events austin texas
- Are emily and ezra dating in real life
- South african online dating
- Taking your time while dating
- Baby boomers dating services
- Totally free online indian dating sites
- Free speed dating boston ma
- Is it bad dating a younger girl
- Dating website jaipur
- Best dating sites for nepal
- Free online dating sites switzerland
- List of all usa dating sites